ATMEGA324A-MCHR【PDF 26/160 页】IC MCU AVR 32K 20MHZ 44QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3761

22页 23页 24页 25页 [26页]27页 28页 29页 30页

121

8272E–AVR–04/2013

ATmega164A/PA/324A/PA/644A/PA/1284/P

Figure 16-4. Output Compare unit, block diagram.

The OCRnx Register is double buffered when using any of the twelve Pulse Width Modulation

(PWM) modes. For the Normal and Clear Timer on Compare (CTC) modes of operation, the

double buffering is disabled. The double buffering synchronizes the update of the OCRnx Com-

pare Register to either TOP or BOTTOM of the counting sequence. The synchronization

prevents the occurrence of odd-length, non-symmetrical PWM pulses, thereby making the out-

put glitch-free.

The OCRnx Register access may seem complex, but this is not case. When the double buffering

is enabled, the CPU has access to the OCRnx Buffer Register, and if double buffering is dis-

abled the CPU will access the OCRnx directly. The content of the OCR1x (Buffer or Compare)

automatically as the TCNT1 and ICR1 Register). Therefore OCR1x is not read via the high byte

temporary register (TEMP). However, it is a good practice to read the low byte first as when

accessing other 16-bit registers. Writing the OCRnx Registers must be done via the TEMP Reg-

ister since the compare of all 16 bits is done continuously. The high byte (OCRnxH) has to be

written first. When the high byte I/O location is written by the CPU, the TEMP Register will be

updated by the value written. Then when the low byte (OCRnxL) is written to the lower eight bits,

the high byte will be copied into the upper 8-bits of either the OCRnx buffer or OCRnx Compare

For more information of how to access the 16-bit registers refer to ”Accessing 16-bit Registers”

on page 113.

16.8.1

Force Output Compare

In non-PWM Waveform Generation modes, the match output of the comparator can be forced by

writing a one to the Force Output Compare (FOCnx) bit. Forcing compare match will not set the

OCFnx Flag or reload/clear the timer, but the OCnx pin will be updated as if a real compare

match had occurred (the COMn1:0 bits settings define whether the OCnx pin is set, cleared or

toggled).

OCFnx (Int.Req.)

= (16-bit Comparator )

OCRnx Buffer (16-bit Register)

OCRnxH Buf. (8-bit)

OCnx

TEMP (8-bit)

DATA BUS (8-bit)

OCRnxL Buf. (8-bit)

TCNTn (16-bit Counter)

TCNTnH (8-bit)

TCNTnL (8-bit)

COMnx1:0

WGMn3:0

OCRnx (16-bit Register)

OCRnxH (8-bit)

OCRnxL (8-bit)

Waveform Generator

TOP

BOTTOM

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式